carbide claw chisel with continuous carbide plate shank 10.2 mm

Diamond pneumatic claw chisel shank 10.2 mm with continuous carbide plate. Total length approx. 200 mm - 220 mm.

The teeth are ground into a continuous carbide plate. This results in extremely sharp teeth that allow the stone to chip easily and facilitate the finishing of surfaces. On the other hand, this variant is more sensitive but cheaper than a claw chisel with individually soldered carbide pins. The claw chisel should be loaded evenly over the entire "row of teeth". We recommend using a pneumatic hammer with an impact frequency of 6000 blows per minute or more.

The name Diamont refers to the high hardness of tungsten carbide, the material from which the tool cutting edges are made. Diamont tools do not contain any diamond components.

General information on carbide chisels:

Sculpting tools made of carbide or with carbide inserts are particularly suitable for working hard types of stone. Carbide tools need to be resharpened less frequently during work, as the material is so strong that there is less abrasion than with tools made of forged steel. The carbide cutting edge therefore has a longer service life. However, if carbide chisels are ground very sharp or thin, careful working is required, as carbide is a brittle material due to its hardness and can easily break when ground thin. Levering movements when hammering can also lead to breakage or loosen the carbide pin from the steel casing.

The rule of thumb for hard stone is: the harder the stone, the blunter the cutting angle of the chisel should be. With hard stone such as granite, the chisel is placed at almost a right angle and the stone is virtually pulverised. The chisel therefore has a very blunt cutting edge. For crystalline stone such as hard marble, a more pointed tool with a sharper cutting edge is required. The chisel is set flat so that the stone can chip off without damaging the underlying crystalline structure.

Carbide chisels can also be used for working sandstone. As sandstone is highly abrasive, forged steel chisels can wear relatively quickly. Carbide cutting edges have a longer service life due to their hardness. However, it should be noted that the carbide pins are usually set in steel.

As with crystalline rock, pointed chisels tend to be used for working sandstone: the aim with this type of rock is to destroy the bond between the sand particles when striking, for which a pointed tool is better suited than a blunt one. However, the same applies here: for very hard sandstone, use less pointed chisels that are less likely to break.

You can find out more about the special features, production and quality of BAVARIA carbide tools in an interview with Andreas Weber, owner of BAVARIA Steinmetzwerkzeuge.