All prices incl. VAT, plus shipping costs.
For deliveries to countries other than Germany
the final prices may change in the checkout.
MORE INFO
Ideal for CUTURI pneumatic hammers. For regulating the compressed air volume directly on the pneumatic hammer. With 1/4'' female thread and 1/4'' male thread.
Brass tap in a compact design for installation between the pneumatic hammer and flexible compressed air hose for convenient regulation of the amount of compressed air arriving at the pneumatic hammer if the pneumatic hammer does not have a corresponding compressed air regulator, as is the case with CUTURI pneumatic hammers, for example.
To fit the end of the flexible compressed air hose with an air flow control, screw the screwed hose connector with 1/4'' external thread (art. 258046835) into the 1/4'' internal thread of the air flow control, insert the end of the hose connector into the hose and secure with a suitable hose clip.
Caution: The compressed air cannot be completely switched off with the air flow control! To be able to switch off the compressed air, the air flow control can be combined with a ball valve. The additional installation of a ball valve allows the compressed air to be switched on and off near the pneumatic hammer without having to switch off the compressor.
To install a ball valve, cut the flexible compressed air hose in two at the end that will be connected to the CUTURI pneumatic hammer, approximately one arm's length from the end of the hose. Insert a screwed hose connector with a 3/8'' external thread (art. 258046823) into each of the two hose openings created in this way. Secure the screwed hose connectors with suitable hose clips. Screw the two hose ends to the ball valve using screwed hose connectors.
